Troubleshooting | BT1 not pairing when sending multiple RS-232 commands

Learn how to resolve a pairing issue when multiple RS-232 commands are sent.

Updated at April 19th, 2023

Your engagement helps us create the content you need. Click here to review this article.

Table of Contents


BT1 will not complete pairing when sending multiple RS-232 commands.


When the BT1 receives multiple commands, it will process them sequentially as received cutting off the previous process.

Solution | Workaround

A delay between commands is needed to ensure each process is completed.


If issuing the BTB command to initiate pairing, you must then wait before issuing a BTS for device status (5-10seconds should suffice). If you request a status before the unit has had a chance to connect, the pairing will fail.