TSC G3 will not load a design when using QDS <9.4, 9.5, 9.6
If you are not finding the results you need and still have questions, submit a request using the form below and our Tech Docs team will get right on it. Our goal is to provide the content you need!
Your engagement helps us create the content you need. Click here to review this article.
Table of Contents
|Hardware Model/Series||TSC-50-G3 TSC-70-G3 TSC-101-G3|
|Software||<9.4.0 - 9.4.4, 9.5, 9.6|
Your TSC-G3 does not run a design and either shows up or missing or reports a fault stating “unsupported hardware” in it's status block after a design starts in the following FW builds
- All Software versions built before, and including 9.4.4
TSC-G3s manufactured after March 2023 were upgraded with new a LAN Controller (Hardware ). Software support for this LAN controller was added into Q-SYS Designer 9.4.5 (and every LTS build after) and Q-SYS Designer 9.7.0 and beyond. Firmware versions listed above do not have software to support the upgraded LAN Controller hardware.
Below is the Serial number cut-in date when Q-SYS started using new LAN Controllers for each 3 models:
- TSC-50-G3 14TW2312xxxxxx
- TSC-70-G3 14TW2312xxxxxx
- TSC-101-G3 14TW2312xxxxxx
Any TSC-G3 manufactured after this date will have a new LAN Controller
Solution | Workaround
User must upgrade their Core/System to QDS 9.4.5 (or later LTS build) or at least QDS 9.7