Awareness | Potentiometer (10K Ohm, 12V) configuration and behavior for QIO-GP8x8
Learn how to configure a 10K Ohm, 12V Potentiometer for use with a QIO-GP8x8 device.
Information
The following is an example of general configuration and behavior for Potentiometer (10K Ohm, 12V) input on the QIO-GP8x8.
This setup is typically used for level control.
Requirements
- Should be a 10K linear potentiometer.
- “Whetting” requires voltage from 12 VDC pin.
- “Wiper” feeds variable voltage to GPIO input.
- Requires Ground connection to Core as well.
