How To | Set up a VLAN ID in Q-SYS Designer
Learn how to configure a VLAN ID for your Q-SYS Designer software system.
Your engagement helps us create the content you need. Click here to review this article.
Table of Contents
Procedure
You actually don’t set up VLANs and their IDs in Q-SYS itself, but in the network switches. Q-SYS does not have any IEEE 802.1Q function for VLAN tagging.
In the switch setup, designate access ports and assign them to VLANs as needed.
For example, here is a set of commands for designating a voice VLAN and naming it VLAN 10 on a Cisco IOS-based switch.
config t
description Q-SYS VoIP
int g1/0/10
switchport mode access
switchport access vlan 10
no shutdown
exit
wr mem