Error | "Block processing not supported on this model Core"
Learn how to troubleshoot a core error when block processing is not supported.
Affected Products
| Hardware Model/Series | N/A |
| Software | QDS when Check Design |
Message
"Block processing not supported on this model Core" from Check Design.
Definition
This message can be an indicator that the Maximum DSP Property for the Core has been set to "No". A verification of this will be shown by Category 1 Processing only being shown as available in Check Design.
Solution | Workaround
If there are no Category 2 processing blocks in the design (AEC, NFC), this message will not display. The message is thus an indication that both types of processing are required by the design, however the Property to enable such has not been selected.
For further information, look under the Properties/Core Properties section of Status (Core) in the Q-SYS Design Help.